Search:

I have had good luck with Sherwin Williams Sher-chem. The primer is a bit high, but the paint is reasonable. I actually shot some with a $10 Harbor Freight gun after finding out a piece was missing...

I have a question that I asked on another forum. I am refurbishing some hand planes. If you were buying would you prefer jappaning, paint, or powder coating? Since I have my surface grinder rebuilt,...

May not work, but I would try loctite if there is enough treads left. Be sure and get the blue. That one is for a screw that can be removed.

Working on restoring a covel surface grinder. I am using a Teco Drive like these http://www.factorymation.com/acdrives

Will this work?

http://cdn1.grizzly.com/manuals/g1035_m.pdf

The blade moves up as the foot pedal is pressed. There is large wingnut that is used to lock the blade in place. The table will tilt up to 45 degrees.

just wanted to say thanks for all your great comments

As I bought it.

365482365483365484

Here are more pictures taken during rebuild. It will usually start with the first pull, but don't try to pull if engine is on compression stroke. The old motor name plate was trashed so I removed it...

yes the blade comes up through the entire slot. The bolt holes are for the miter gage.
.365471

Yeah, I am surprised that it is the only CM piece on there. They were heavy into pumps and hoist. I am working on an old Covel surface grinder right now. Had to have parts machined since Clausing has...

No, the top is steel. The foot pedal raises the blade. I don't have the fence or miter gage but I don't plan on cutting anything with it. The blade is only a 12" steel blade, but it has a 1 1/4"...

I haven't been on here for quite a while so I wanted to post pictures of this saw. As you can see it wasn't in good shape when I bought it. It took a lot of work to get it in this shape. I matched...