Search:

Thank you David
-Sam

Does anyone have the information (product #) of the DW735 cutterhead bearings?

I recently bought a cutterhead for a DW735 planer; it did not come with ball bearings on the ends of the cutterhead....

Forgot to mention that I took the DC to pieces: the impeller was taken off the motor shaft; however, I do notice without a load the motor runs a bit longer before tripping the breaker.

-Sam

I suspected that too. Bought a new capacitor with the same rating and put it in; still the same problem.

Thanks
Sam

I recently bought a dust collector off CL. It has a motor of 1.5HP, single phase, 220V. The DC brand is Bridgewood, made in Taiwan in 2003. The induction motor nameplate says 12 amp, which indicates...

I was not sure if there is a particular tool or method that can be used to easily remove the pin in my situation; if there is, it could be easier than removing the stripped screws. The post was not...

The hinge is on the inside of my house.
Thanks
Sam

SMC folks,

Here is my issue: I plan to remove the entrance door of our house and re-paint/-coat it and try to figure out an easiest way to take the door hinges off. Among the three hinges on the...

Thanks all for the suggestions.

The moving works out pretty smoothly: guys in the warehouse used a forklift to load the saw/pallet into the back of trailer and then uses anther pallet as a fork...

Hello

I recently bought a vintage Powermatic 66 table saw (1970's) for restoration through a school auction in another city (200 miles away). I plan to move the machine using a U-haul utility...