Thanks for the info. A few things I forgot to add: the seller is approx 4 hours from my house -- this makes it a bit hard to determine overall condition.
The asking price is $450. I thought the...
Type: Posts; User: bill bruno; Keyword(s):
Thanks for the info. A few things I forgot to add: the seller is approx 4 hours from my house -- this makes it a bit hard to determine overall condition.
The asking price is $450. I thought the...
Hi folks,
Came across the below Oneida cyclone. It has a 2-hp single phase Lesson motor. The cyclone has a 12" impeller and 7" inlet. I can't find any info on Oneida's website. Is this unit an old...
Phil, if this saw is an ICS (the top of the line for SawStop) is it a very good deal even if you have to replace the motor. A new Baldor 3 - 5 hp motor costs about 500 new (you can do even better...
Hi Cliff,
When you insert the cartridge there is a red key that's inserted and pushed down to lock the cartridge. If the key is not locked down tight you will get the flashing red light. Try...
Hi Paul,
I vote for the SS. I have the SS – ICS. The SS, to me, is the best built, has superior customer service and the brake is a bonus. Just an additional thought: when I attempted to sell...
I agree with Eiji Fuller. I also have many Festool products. But I would never give up my tablesaw (other Festool products -- yes). As Eiji indicated, checked Jim Toplin’s book.
Hi Steve,
I'm also in the market for a slider. When you view the Grizzly G0623X be sure to check the position of the sliding table support leg at the front of the saw (where you begin the cut). I...
Hi Ray,
I have a SawStop and it is a great saw! Have you tried to contact Steve Gass at SawStop? He is the inventor and an incredibly creative individual. Hope this helps.
Thanks later bill
Hi Darren,
To the best of my knowledge a circuit should never run at more than 80% capacity. For example, a 20 amp circuit should have a max load of 16 amps. Hope this helps.
bill
Hi folks,
Thanks for all your great inputs! Richard, like you, I will be upgrading from an ICS SawStop. I really like the SawStop (owned # 12 off the production line since ~2005) but because of...
Hi folks,
This is my first post and I would like to thank everyone for all the great guidance! I’m contemplating purchasing a combo sliding tablesaw/shaper. During my research a salesperson...