Thanks Rodne for all the replies
I have called the GCC for problem
regards
Type: Posts; User: sunil jain; Keyword(s):
Thanks Rodne for all the replies
I have called the GCC for problem
regards
Dear Rodne,
Did the laser also stop firing when the head stopped? Yes
Does it try to boot? No
Any movement of the x or y axis or the table itself? No
Is perhaps the table touching the upper...
Hello to every one,
Suddenly during cutting 3 mm acrylic, head stopped moving . And when i restarted the machine
LCM Version <<5>> was displayed and the machine was hung.
Kindly help for above...
Rodne, thanks for providing measurment.
regards
yes, blue tool.
Dan, mathematically you are 101% correct.
If you have gcc spirit with 2' lens, please measure the leg of manual focus & tell me.
hello to everyone!
i have gcc spirit 25 watt with standard 2' lens. i have lost manual focus.
can any one tell me the exact length in mm of manual focus.
Thank you every one for support.
due to increase in workload i assembeld the tube. after cleaning the dust thoroughly. repairing the fans (one was jammed), doing optics alignment... the machine...
Thanks
Viktor Voroncov
Richard Rumancik
now I have assembeled the tube and will work next day.
its night here
so good night... to every one
regards
mfg date of my tube is may 07 2006 (printed on sticker)
where as i received the machine in dec. 2007.
yes, same detachable cover on opposite side.
full view of tube...
No, my engg. has not checked with multimeter. he suggests to replace the capacitor if it's blown off by observing.
The capacitor fitted pcb is not easy to remove, because the transistors on pcb...
I have not found any capacitor or circuit broken inside.
what else the problem nay be due to.
What is the red circled marked board called which is the RF board. We have expert electronic engineer, but is it safe to open the tube? Kindly elebrote in detail about fixing of tube.
regards
Thanks for all of you.
1. Rodne Gold:-
it get darker few lines and lightens till last. machine cuts 3mm cast acrylic ay 2.8s/100p in enhance mode.
sometime it is light from starting and...
Hi...Viktor...
1. i usually engrave on steam beech. the engraving with dark band and light band are marked.
2. the same problem is observed with acrylic and other material
3. the result varys...
hi to every one...
Today I faced following problem with my GCC 25 watt-
First few lines are engraved dark and then suddenly engraving lightens.
optics are clean.
Any one help me on this problem....
the problem is due to virus. i also got the problem. reinstall xp then every thing is fine.
Thanking you guys,
i strectch graphic 10-15% to increase dot size. I will try to engrave the graphic at same dpi and see for problem
I use corel photo paint. decrease brightness by -20% and increase intensity by +20% and then convert to grey scale & then try the result.
I use parallel port for data transfer.
i have engraved successfully larger files earlier.
I have tried the photograph with different dpi.
The fille successfully works with 500 dpi. but gives...
Hi to every one
:Spirit 25 Watt
Engraving stops at half of the image and error message PCL command error, Press any key to stop is displayed.
Any one faced this type of problem help me.
Hi.
Though I don't post. I am regular reader.
I heartly Thank every one for sharing brilliant ideas
Today I got job for silk screen printing on plexiglass. I need help to know what type of ink prints best on plexiglass. Also need some tips for beautiful printing.
Kindly help me for above job.
Richard:
before mirroring, images engraved are perfect. i got the problem with fill 100% black