Search:

The big shroud that funnels the dust into the pipe.

Mine did not come with that. Crap.
Thanks

How did you adapt the shroud to the stand. I have the grizzly stand but as I mentioned above, the shroud and stand have almost the same OD and ID and do not slide together. Was thinking about using...

How did you adapt the stand to fit the dust shroud shown? I have one of the big b\gulp shrouds but the end toward the dust collector is almost exact size as the end on the stand coupler.
Thanks

Didn't do a test board but, did put on triple e this morning, followed by Mylands wax and then a coat of Renaissance wax. It looks good.

Triple e is a similar product to acks.

I have a white pine cup/ pencil holder that is live edge with the pine bark still attached around the top. I thought about putting a few coats to help protect the bark around the top and then...

I am moving from a Nova galaxy DVR lathe to a Robust American Beauty and the way I had my dust collector port next to the Nova will be less than ideal for the Robust AB. I will need a bit more...

How do I send a private message to Jackie Outten?

I was a paid member last year but that has run out. I also had PayPal last year but I no longer have PayPal and will not be getting it again . Is there another way to become a paid member again?...

I turn a lot of salt shaker pepper grinder combination pieces for sale at craft shows. I have a 3/8 inch threaded mandrel that has two rubber bushings on it that can be expanded to hold the ID of the...

Hi Richard, I cut off a glue block while the piece is spinning on the lathe. I use a part off tool and cut through the glue. Works well for me. Using my left hand, I catch the spinning bowl as it...

I have used hot melt glue lots of times. I often glue a block to the base of a segmented bowl and use that joint to completely turn the outside and inside of that bowl. Then cut the block off the...

Is one of those species red palm? Images of red palm sure look like what I have. Real pretty wood and easy to work. Wish I had larger pieces.

The lighter wood is maple for sure. The darker is the big question mark. Red Palm, I'll check that out. Thanks.

Actually works pretty easy. I was thinking mahogany at first too but others have told me it's not mahogany. I haven't worked with any exotics so, I'm in the dark. This stuff has been setting around...

I ran into a friend I had not seen in many years and he asked if I wanted this old box of end cuts he has had setting in his basement for a long time. He was given these a long time ago and he didn't...

Thank you. That gives some clarity on the subject.

Not the fountain pen or the straight dip pens but the offset calligraphy pens made for right and left hand writers? Yoke pen Company has some of the hardware but I don't see how you mount the flange...

The ones I have tighten CCW.

I have two Super nova 2 chucks and several different jaws for them. I would like to pick up a couple more nova chucks and some different jaws as I do not have every jaw set they make but, I notice...

a dust collection port right under the table but, the Shop Fox has a second one down at the bottom back of the machine. I have no idea how much dust would get past the first one.

I am mostly a wood turner but do some flat work as well. I have been considering replacing my 14 inch bandsaw with a larger model. I have been looking at the Grizzly 19 inch G0514x for $2,050 plus...

I have started roughing out some bowls with this walnut. I have six roughed out and sealed, six more to go, unless I just decide to leave a piece or two to see what happens.

Sounds like sage advise. Thank you