Search:

Heres a thought, cut it in half again..so quarters. then you just have to cut the point off the "triangle" or innermost part of the log.

WOW , just WOW!

Alrighty, I was in your shoes about a year ago, looking heavily at that Woodland Mills 126, also looking at everything else out there at the time. I bought the Woodmaxx 26e. It had what I thought...

Yeah, been fixing stuff for years! Mine had a set screw on just one end of the bar holding it. Just a matter of getting in to it and figuring stuff out!

Indeed, I actually used the anvil on the back of my vice and a 2 pound mallet to nicely convince them to flatten out! ;-)

So I threw all the parts, except the rod they hang on, in a tumbler for a...

Yep, I removed the whole unit from the machine today. Turns out a couple of the fingers were bent causing the assembly to be too wide to fit between the keepers on the ends of the rod and working...

Yeah, I think I’m going to have to figure out how to do that!

So I have a Jet JWP160s planer and I need to clean the anti kickback fingers on it. They are supposed to hang freely on the rod they are on, but mine do not! I can push them up and they stay up! ;-(...

Thank you very much for the video, I keep seeing people saying they use their RAS, but I wasn't understanding how they were doing it. Couple questions for you. Just mount that wheel like a stacked...

And that would cost more than my planer did!

Thank you!

Great insight, thanks..

Sorry bout the extra thread but the "edit post" on my sharpening thread was gone.

So I just bought a used JET JWP160s planer. I'm looking to buy an extra set of blades for it. JET blades are...

I've been looking at that Grizzly grinder, how do you like it? Will it do anything besides planer and jointer knives?

So I'm liking some of the ideas on here, but my planer manual (JET JWP 160s) shows a dual angle grind on the blades.. Is this normal? and do you guys use the 2 angles when you sharpen?

Thanks for the heads up, just installed a second 220 circuit in my shop so I can run my planer and dust collector at the same time.

So going through stuff on this planer I noticed it was only...

I wonder if you have a pic of this set up you could share please?

So how do most of you guys go about this task? Do you just send them out, or do you do it yourselves?
I just picked up a JET WP160s that came with a couple extra sets of knives so I need to tend to...

So I bought the jet, now to go through it and clean it and make sure its all set up correctly.

It really depends on your use for it. Like others I have both. the RAS (craftsman I've had for 20 years) serves me well and is in a stationary set up, even though its on a mobile base. My Hitachi 12"...

Good for you, a bench top planer will do you lots of good. I have a Delta 12 1/2 incher that has served me well for going on 20 years now. I've got mine in the center of a 20 foot bench set up ,...

So, UPDATE:

After much deliberation I've decided to take a 3 hr drive Sunday to look at and most likely purchase a Jet JWP 160 open stand planer. It comes with a mobile base, 2 extra sets of...

He is in Raleigh

What is it you have fore sale, and where are you?

I did not. After lots of thought on the matter I decided it was just to big. Even with the base it would be hard to move due to its weight and size, and from everything I read my chip collector...