Search:

https://www.youtube.com/watch?v=VkSmaFAuaH4

Instructional video

The Black is soft
The pearl(white) is medium
The grey 602 is firm
And the natural are extra firm

One of the first garage projects was mounting a wall sharpener. My father had one so it seemed the right thing for me to do.

Not for garage use but the best point you can get. This combined with...

I dont think they want me dead just to suffer.

I would say lightning. If it is Ok to have a wooden one attached they must be afraid of lighting striking it and setting the house on fire. Tell them youll put a nice big ground rod on it.

Benchtop could be useful but not as useful as a floorstanding. I watched a video from Bent on youtube this morning he was complaining that he bought this drill and put a woodpecker table on it...

The helium pump or the operation?

Festool ets sander are more comfortable with less vibration and they will probably last longer than $50 options but in the end i would assume they sand at the same rate as the $50 units
Good paper...

My wife is a violent sleeper so I have caught quite a few elbows there. Ive had my 2 year old at the time daughter shove her finger so hard up my nose it bled for an hour. Ive been poked in the eye....

518559

How about this?

I fall going up them while facing them or at least misstep alot. They are too close together,in height

David, have you been re flattening iron every sharpening? I cant think of how it no longer will tighten properly unless the iron has gotten thinner. You can check that the cross bolt that the cap...

Yes there is a power button.Once you push the power button it can remain on indefinitely. the paddle will be your power. but you can always turn it back off....

Try searching this on walmart. When I clicked on the link Jim put up My capital one shopping mentioned they had it cheaper. Perhaps they do better over the great north wall than amazon.
Spotnails...

Im seeing alot of new commercial buildings with a split tread left and right at different heights. They are awful, but what they do have is a central hard plastic raised bump for sliding equipment up...

Has it ever been dropped?

The Domiplate is a very nice addon to the domino for cabinet work but the fence should be square on its own

I wonder sometimes if this is one of those things where you buy it and then get a package with 2 lbs of heroin and a cheep drill bit.

I would suggest following this as a maximum in angle. The rest is based on what your working with as far as height and travel....

I started with the ets ec 125 and switched my main sander to the Mirka. The paddle requires very little effort to hold. It has a power button then all goes through the paddle. Once its on you cant...

https://www.freightquote.com/

Or a site like it will provide decent quotes for LTL. You will need to palletize, know how much it weighs, and dimensions. They will pick up with a lift gate if its...

I bought it to complete a christmas gift. It only took an hour before I got it to make noise. I downloaded lightburn and used the free trial to calibrate machine and setup a job. after that I changed...

Is this a combination machine?

Definitely look at 6" there is a decent time savings with the 30% more surface area and paper is only about 10% more in cost.

If you have lots of 5" on hand I know at least the Mirka allows...

I bought the Grabo last summer and it allowed me to maneuver 50 pieces of sheet goods through my small shop with little back pain. The hardest part of the lifting of sheet goods is the awkwardness...

Spongy or "punky" wood is usually stabalized with epoxy. I know knife makers and pen makers do this if they work with spalted woods.