Thanks Doug!
Type: Posts; User: Keith Winter; Keyword(s):
Thanks Doug!
Anyone have a source for 1/4" white oak?
For what it's worth I've tossed a number of those green Chinese blowers, utter junk. The $80 harbor freight would be well worth your money to upgrade. With a coupon you can get it even cheaper some...
Looks great Don!
Thanks guys, it's about 11 months old.
Thanks Ron,
Had my guy get on with china last night. Took a few hours but they got the rails straight again. Most of time due to the language barrier, but the Thunder people were helpful!
Ron what would an ac store be called? Did some googling didn't find much except ac repair technicians like you'd call to your house.
Thanks Bill long ways away unfortunately in Oklahoma :)
Thanks, great suggestions all around. I think I will see if there is an ac shop I can take it to per Rons suggestion.
Seems today is not my day....
Employee just ran the chinese laser into some wood knocking the middle rail out of alignment. It's a thunder laser, similar case to the gweikes I believe. The middle...
Ok so I don't know a lot about compressors and such but here goes ;)
On the left side the black thing I'm pointing to that appears to be the compressor yes? It is vibrating so it is running, it...
My other chiller the same room is working fine, was working fine for 6 months until today. The CW series chillers are adjustable from 15c-30c. It's about 65 degrees in the room right now (18.3 C),...
My chiller is behaving oddly. It's only 60 degrees farenheit in the room but it's having trouble chilling the water down to 19 degrees Celsius even with the laser not running for many minutes at a...
Thanks for that photo Kev, I can see how that would be handy. Photo is a thousand words!
Thanks everyone for the replies. Haven't solved the mystery yet. Emailed china waiting to hear a reply.
I have a couple chinese lasers using RDworks as the software. All the sudden autofocus stopped working on both of them and the tip just runs into the substrate if you try to auto focus and doesn't...
Great ideas thank you!
Not sure all the trotecs do it. I wonder if that can be disabled? Would fix the problem...
No it's screwed on from below. You'd have to get under the closed cabinet to access from below. You can disassemble the screws holding the bed to access it but that takes about 20 minutes to do and...
What happens, not often but time to time, is the operator leaves what he was working on the night before on the bed. When he turns it on in the morning it automatically lowers. When it automatically...
Hi Jit,
You're on the right track there but the bed actually goes lower than the front lip. So if something falls behind the laser. You shut off the laser and turn it back on the next morning it...
From time to time small objects fall off the back of the Trotec Speedy 400 bed, there is a gap behind the table that allows this. Problem is if something falls off the back while the bed is up it can...
Impressive job lining that up!
1 in this situation. You are simply resizing the logo it sounds like. All the main setup work is done on the 1st. Now if they are two different logos then two setups would apply.
There are "redsail" knock offs. Meaning others that use the same case that are not redsail. Did you buy it from eBay, if so which company did you buy it from?