Search:

Thanks. Went to grizzly site and they were on sale.

Yes, I meant base. Dang autocorrect. Thanks got the info

Any suggestions will be appreciated. Don’t need to go more than a few feet to get better rip path capacity

Thanks. I will do that

Some clarification, the speed seemed steady but the motor hum seemed to pulse.

I joined at much more than minimum contribution. I always figured if you bought a $50 book and learned 4 things you would not know otherwise, it was money well spent. I am sure I will need, and...

I assembled the bullet motor today and test ran it on the table top. Good news is it ran. When I killed the power it took a long time to coast down to stopped, so I feel good about the bearings. ...

Ah, will contribute. Was planning to but didn’t see the requirements for PM. Thanks

I tried to get them from motion industries but they didn’t have them in stock. Also tried to get a sheave from them but haven’t heard back after they said they needed to research it

Sorry I am new here and can’t figure out how to PM. Will try to find some tech help on that

sheave Has 0.75” arbor, 5.5” diameter and 3 belt, 1.75” thickness

According to a bearing supplier here in town, the 1.75” thick, 3 belt pulley is not common now. Most will be 1.5”. I was leaning toward replacement of the arbor bearings but have a nagging feeling...

I am so glad to have the opportunity to tap into the wealth of knowledge in this community. In 2016, we had a lot of flooding in the Baton Rouge area. A friend of mine bought some flooded tools...