Thank you all for the replies. No real consensus yet. Most of my work will be in the 16" length x 4 " width if that matters at all.
Type: Posts; User: Greg Fairweather; Keyword(s):
Thank you all for the replies. No real consensus yet. Most of my work will be in the 16" length x 4 " width if that matters at all.
I need help deciding which tool to use (easiest) to make box joinery with. I am mostly interested in dovetail and double dovetail joints, however I will also use mitered and splined corner joints. ...
Thanks Curt and Jim. Yes I will likely have to purchase veneering supplies and make them myself. Is mdf a good substrate or should I stick with plywood for veneering?
Is curly maple plywood (3/8" or 1/2") available in sizes other than those for small hobby work? I am unable to source pieces at least 10" x 20", and really do not want to (although will if needed),...
Not to thrilled myself, however if I am doing multiples boxes, I may bite the bullet.
Thanks Alan. Very interesting and useful find. May have to buy a bandsaw now.
I received a quote for a bit that has a cutting height of 2.5". It would be $353.00. Ouch, but might be worth the expenditure. To keep the profile looking correct what radius would look best? I am...
Thanks Stan, that helps. Right now I sent enquiries out for custom sizing. Will see where that leads me.
Alex. Cancel that. I believe I found the bit you used. MLCS #8592.
Those are beautiful boxes Alex. Can you point me out in the right direction for the bit you used. I have searched MLCS but do not see an appropriate one.
I believe your last assumption would be correct, Now to find a 5" cutting height shaper cutter. :D
Are the sides of the boxes shown simply beveled at the table saw after glue up? If so, what angle is it best to set the blade to? I will experiment, just wanted to have an idea where to start.
...
Now I have another issue with the Movento runners. When I close the drawer the soft close does not pull drawer in if I have utilized the tip on for opening. If I do not use the tip on the drawer...
Thanks to all for the assistance. It appears Christopher was correct and that somehow the spindle was turning in the reverse direction. I will have to test later today on the burl but that is...
I am using a spindle from automation direct. It is an air cooled 2.2 kw off shore brand that has not caused an issues thus far. I have however ordered another of the same in case that is the problem...
I have a cedar burl that I would like to carve into using my cnc machine yet it is burning when I attempt to do so. I am using sharp bits, fast feed rate and have tried various spindle speeds to no...
Thank you for the responses. I will proceed as advised.
Title says it all. I am confused as to the size of drawer needed to be built to fit opening. I have not received my slides yet and would like to build prior to receiving them. I will be using 1/2 " ...
Thanks to all for the sage advice. The client has agreed to do the project in walnut.
Thanks for all the advice. I will talk to the client regarding suggestions.
I am planning on building a side table like the one attached from maple (curly?) and purpleheart. I would like suggestions as to which species would look best for each part. I feel that purpleheart...
Absolutely stunning. First build-hard to believe. Love the finish.
Jay;
Thanks for the pics. Is the panel veneered or is it solid? I am not sure that I could come close to your quality but those are similar to what I would like to build.
Greg
I do love the look of hickory, however I am primarily concerned with the expansion/contraction characteristics of the wood I finally choose. I live in Alberta, Canada where or moisture conditions...
Thanks Shawn. I may attempt the technique at a later date.
Greg