I had personal experience with Fiber on Black Acrylic that the results far better finish with white appearance, and sharp than CO2 Engraver, and with 20w IPG earlier had good work with wooden...
Type: Posts; User: Rangarajan Saravana kumar; Keyword(s):
I had personal experience with Fiber on Black Acrylic that the results far better finish with white appearance, and sharp than CO2 Engraver, and with 20w IPG earlier had good work with wooden...
Yes cleaned bearings, rails, encoder
Sorry for my wrong interpretation.... when the laser takes the home postion, was running smoothly when a program sent. Suddenly at a particular point, it was stopping due to mechanical
failure. I...
Hi,
My Epilog last week got faced a problem, suddenly stopped while running. So, i emailed to techsupport and suggestion is to tighten the y belt. After that, i tightened , new problem is
the...
Fantastic Journey to continue with.... All the best
Regards
I wish to have my rotary for fiber laser to get it used as almost 4 yrs over with that.. Bit scary
regards
Hi,
I have a chinese machine with laser controller RDLC 320A with recent problem , as i feel culprit in the controller.
1. when i start the machine , it doesnt respond to move in either x axis...
If you have to engrave on metal , galvo i prefer IPG pulsed laser 20w to 50w can be sufficient depending on your use... but there are lot others
As i have limited experience with IPG laser, so...
Yes I agree the groove looks rough after bending, we do flame polishing inside the groove for 8mm, later bend
no problem in look wise
regards
Replace cable and try again
regards
Still very curious to install a glass tube for my epilog 50w legend
Pls update with the photos
Regards
Hi,
Glass tube, pls throw some detail of replacing with Epilog tube
regards
I have a thought that the cutting takes more power with cost ratio in western machine rather chinese machines. So my suggestion is keep chinese for cutting rather engraving, because you
might do...
Recently Rofin sinar has developed laser cutting glass
Search youtube cutting glass thru laser...
regards
Congrats Greg.. very nice to hear the addition. All the best
regards
Hi,
Earlier we had some erratic behaviour in X axis and found that , the rod which carries the air hose, touch the x board seated on the flying optics and caused so many
issues. After that we...
I have had a lot of issues which any machine owner face like alignment, software update, tube, optics... Etc., goes on. But there comes excellent tech support to rescue us. I firmly advice to look...
I always had CMYK as defaut
How to have RGB as defaut?
Thanks in advance
See this if its helpful in pdf ...
regards
Saravana kumar
Excellent and stunning to see it flying.... tks for sharing
Regards
See this could help you in corel 11
Ron,
Did you use the corel trace? the finish seem to be very good? or any extra effort needed?
regards
see if it is ok
sorry your file is not getting opened
rgds
i guess alignment in the machine mirror and lens is required...
regards