Search:

Type: Posts; User: Jeff Goldsmith; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    9
    Views
    2,044

    I just slid 3 of the blades a bit, tightened...

    I just slid 3 of the blades a bit, tightened everything back up and planed a piece of southern yellow pine. The finish looks great, the nicks were small so I am going to leave it at that. I did have...
  2. Replies
    9
    Views
    2,044

    Both are very good ideas. Doug, yes I meant the...

    Both are very good ideas. Doug, yes I meant the bevel angle so I can create a jig to grind the knives down a bit. I think I'll try Mel's idea 1st and see how it works. I'll post after. Thanks guys.
  3. Replies
    9
    Views
    2,044

    Jointer Knife Angle

    I have a Grizzly G0656 and I nicked the knives with a screw. Does anyone know the blade angle?
    Thanks
  4. Replies
    8
    Views
    5,178

    1st and foremost, I need accuracy especially on...

    1st and foremost, I need accuracy especially on the 90 degree cuts and not just chopping but sliding as well. Next was a small front to back foot print, I work out a two car garage, and then dust...
  5. Replies
    8
    Views
    5,178

    very interesting thread over on...

    very interesting thread over on festoolownersgroup, thanks Victor. I need to dig deeper, I'm sure Makita knows where the issue lays now, the question is, did they address it yet.
  6. Replies
    8
    Views
    5,178

    Ted which model number have you owned for 7...

    Ted
    which model number have you owned for 7 years? It seems like you are reviewing a completely different saw. Maybe the 1016?
  7. Replies
    8
    Views
    5,178

    Makita LS1019L Miter Saw

    Hello People, I am looking for feedback on the accuracy of this Makita Saw particularly at 90 degrees but any and all feedback is welcome. My primary concerns are again accuracy, dust collection and...
  8. Replies
    11
    Views
    2,154

    I received the G0656 about a month ago, the...

    I received the G0656 about a month ago, the carton looked like it was dragged half way across the country, thing got beat up pretty bad. Everything was perfect after set up, very nice cast iron bed,...
  9. Replies
    10
    Views
    1,779

    I'm leaning towards the 6090 because the dust...

    I'm leaning towards the 6090 because the dust collection is on the side instead of the back end of the saw. I built a nice (for me) outfeed table that the 1023 dust port would require a 90 degree...
  10. Replies
    10
    Views
    1,779

    Thanks for the info, thinking about replacing my...

    Thanks for the info, thinking about replacing my recently returned G7015P with either a saw from your series or the 6090 series. How do you like it?
  11. Replies
    10
    Views
    1,779

    Dimension between the mitre slots

    Hi everyone I'm a newbie,
    I would like to know the dimension between the mitre slots on the grizzly 6090 and the 1023 saws.
    Thanks in advance.
Results 1 to 11 of 11