Search:

Type: Posts; User: Maxim Pernatiy; Keyword(s):

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    573

    Engraving wood using fiber laser

    Hello,

    Initial data: Raycus 50wt, 200 * 200
    Material: Plywood, oak.
    Task: Get an engraving.

    After reading the manuals, it became clear that a fiber engraver can not engrave on wood, however,...
  2. Remove paint from steel/ablating parameters for fiber

    Hello,

    We have Raycus 50w with 200*200 and need to remove completely black paint from stainless steel, so at the end there should be no black residue or black dots - just clean metal.
    I'm tryed...
  3. Replies
    10
    Views
    1,111

    Already have a good microscope, please advice the...

    Already have a good microscope, please advice the procedure and parameters for check factory driver defaults and galvo motor check.
    Thanks in advance.
  4. Replies
    10
    Views
    1,111

    Its weird, but when I move my laser head table...

    Its weird, but when I move my laser head table block (i have portable fiber) from my iron workshop table to the floor - there are fewer lines in this case, but they are still exist. Maybe the reason...
  5. Replies
    10
    Views
    1,111

    I have the following TC settings: 419966 I've...

    I have the following TC settings:
    419966

    I've change the TC settings to yours and get different color result(no white):
    419967

    And when I change the TC settings and check "All calc" I receive...
  6. Replies
    10
    Views
    1,111

    Also one of fiber machine setup specialist on my...

    Also one of fiber machine setup specialist on my side tell me that the reason of the lines may be due to vibration and unstable head of the laser.
    For the first I remove all vibrations with my...
  7. Replies
    10
    Views
    1,111

    Hello Kev, Thanks for your reply. I have...

    Hello Kev,

    Thanks for your reply.
    I have test using your parameters:
    1 loop
    Line Width - 0.06
    90power\1000 speed\50freq\45* angle cross hatch
    - 3 loops
    Line Width - 0.1
    35...
  8. I have used transfer tape, but it's not an option...

    I have used transfer tape, but it's not an option for engraving a big plate full of text.
    So the issue is still exist and sanding is used in most cases (
  9. Replies
    10
    Views
    1,111

    Can you please explain about ~Stray vectors~ ?...

    Can you please explain about ~Stray vectors~ ? What they are and does change of the hatch always eliminate them.
    Thanks in advance.
  10. Replies
    10
    Views
    1,111

    Fiber laser - not smooth engraving

    Hello,

    I have a Raycus 50wt + 200*200 table.

    Material: Stainless steel painted with black powder polymer paint.
    A task: get smooth bright engraving.

    The parameters were selected for that...
Results 1 to 10 of 10