I have a small basement shop (300 sq ft) that I am installing a dust collection system in. I will only connect one tool at a time, bandsaw, router table, 13" planer, drill press, and 3HP table saw....
Type: Posts; User: Daniel Boddy; Keyword(s):
I have a small basement shop (300 sq ft) that I am installing a dust collection system in. I will only connect one tool at a time, bandsaw, router table, 13" planer, drill press, and 3HP table saw....
Please enter me in the drawing. Thanks!
We have white spindle railings on our covered back porch and gazebo which has not been refinished in about 5 yrs. The top of the railing is 1x6 wolmanized lumber which is held on with a few screws...
I'm installing a dust collection system in my basement shop. I'm using the D-2729 thin wall Sewer drain PVC pipe. I have a 6" header and most drops will be 4" PVC with a short 4" flex hose at the...
Thanks everyone, some good advice. I guess the way to go is to put a blast gate at ever drop and then run 4-5" flex hose down to each device.
I've got a new Grizzly
I've got a new Grizzly G0548ZP - 2 HP Canister Dust Collector and an XL SDD. This is my first dust collection system so I have some comments and questions. I would...
Thanks for all of your suggestions, they make sense. I repeated the job with a new piece of plywood and cut dadoes about every 3" successfully. And no, I did not stand directly behind the board! I...
407956407957
I'm trying to figure out how to do that. New to forums.
I'm not sure what I did wrong here but boy did it hurt! I think I backed up a bit with the blade spinning. Also maybe because I was cutting so far from the fence. My first pass was good just not...
Thanks guys, good comments. I think I will stay with the XL and scrap the cabinet. The XL has a 6" inlet so I'll use a 6" header and come off of it with 5" and 4" as needed.
Here is a pic of the...
I found a DC cabinet design from ShopNotes which has a cyclone in the top half of the cabinet, a plywood pullout gate that separates the bottom half of the cabinet and in the bottom half you can...
Thanks guys! I am leaning towards the Grizzly 2HP Canister DC (G0548ZP) with the 1-3 HP Dust Deputy cyclone. I mistakenly ordered the XL model of the Dust Deputy and it is huge (sized for 3-5 HP) ...
Looking to buy my first DC. I have been looking at the Bill Pentz website. I will only need to connect to one device at a time. Thinking about getting the Grizzly 2HP Canister DC (G0548ZP) . I...