Ahhh-- Thanks Gary !
Type: Posts; User: dan baldwin; Keyword(s):
Ahhh-- Thanks Gary !
Thank you.
No, but I will do it right now. You said "as he has posted it", did I miss something somewhere ? When I registered a notification said "Your account has been activated but you are...
Any ideas why my registration has not been approved on the Camheads forum ? It has been 11 days since I registered. I was hoping maybe someone here had an idea ?
Thanks
Thanks Bruce ! I'll ponder your 24x36 vs 24x48 suggestion.
Thank you Gary-- I have been reading many of your posts in the past week as I've been learning about CNC using the browser method. I'm very grateful for your experienced wisdom. I did read what you...
Thanks Jim for your quick and helpful response. I have been following your quest in reading through the forum. Congrats on your decision !!
I am just entering the foray of deciding which, if any, CNC machine might be best for me. I am exclusively a hobbyist who, to be honest, is looking for a new toy for my woodshop. I am looking forward...
Thanks all again-- Great info.
Prashun-- I attempted to outline my issue with the Kreg a few posts above (see post #7).
I planned on getting the Incra MastRLiftII as well. I have everything (43"...
Thanks John. This is the kind of scenario I'm curious about. If I go the Incra route, it will be my only router table. Lets say you needed to cut rabbits (for the bottom) and dados (for side hung...
Thanks all-- I'm probably going to go for it (one of these days). The main issue I have with the Kreg fence is with the squaring adjustment screws on the right side. If they are too tight, the fence...
Hi-- I use my current router table (Kreg system) a fair bit. The router lift and bit height adjustment are fine, but I am constantly struggling with getting an accurate position on the fence. I spend...