Search:

Is this how you do it with Gravostyle?

This is how I have been doing it as well in grovostyle... Set it up with the matrix and it just feeds in. Just have to make sure you close the graphics... and then pdf.

Ahh you need to be in New Zealand, we are in Summer here and surfs up!

Very cool! How do you seal it to make waterproof?

I have a Gravograph IS200 and I'm engraving multiple medals. The spindle is not lifting high enough between the jobs and tip is dragging into vice between engraving. I cant work out how to get it...

Thank you Nick. I have reset up with generic/text being default and set up the IS400 in the initial setup, then once that was set up did the IS200 setup within Gravostyle. I still have the same...

You are correct, you can! :) I was doing it before the computer spat the dummy and I put a new HD in. I am in NZ so a slightly different time zone to US, we are ahead of you by about 18 hrs I...

Thanks for your reply. "You don't know what you don't know" but you sure learn thru all the bits of knowledge and experience of others :)
I had a built-in parallel port card in the computer and have...

I have an older IS400 4.3 & IS200 that I have had running off the same computer running Windows 10 with no issues.
The computer died and I have done a clean Gravostyle 8 install on new Windows 10...

CX-1200 Co2 Laser was working fine and had just cut circle. Went to cut next piece and it would not cut. :confused:

Have cleaned lens and mirrors. ..... Didn't work
Tried a different file.......

Thanks Kev for your response. Not sure why machine info isn’t coming up at the bottom of my message, nor how to get it there. I have it on my profile page.


CX1200 - Co2 Chinese laser


...

My laser is distorting the image when on rotary, sometimes makes it narrow, then it could be stretched, then it might then do a correct size, from the same file sent to the laser and just repeated.
...