My experience with the Ohishi stones I purchased from Lie Nielsen, a 1000, 4000 and 8000 is that they are not true splash and go stones. They need a bit of soaking, they also do gouge easily if you...
Type: Posts; User: Matt Riegerix; Keyword(s):
My experience with the Ohishi stones I purchased from Lie Nielsen, a 1000, 4000 and 8000 is that they are not true splash and go stones. They need a bit of soaking, they also do gouge easily if you...
Should have waited to become a supporter. 😜
Sharp chisel, followed by card scraper.
Hi Chris,
The wood is ponderosa pine, I got wet from a local sawmill, air dried it in my backyard.
I had originally planned on filling in the full asa-no-ha pattern like this smaller grid I...
Thanks,
Unfortunately, a few feet tall wouldn't stop these cats.
Laying out the half lap joints was helped by some clamps.
508604
508605
508606
508607
508608
Hello,
Longtime reader, rare poster. Trying to answer the call for more project posts. We had a problem with our cats causing mischief in our bedrooms, to put it kindly. We wanted to allow airflow...
I was lucky enough to have some teak scraps to laminate into a sharpening bench top. It’s holding up well, though I tend to wipe up excess water when I’m through.
Great work. I’ve never experienced tear out with a scraper, I always use the scraper to fight tear out.
The listing says it’s made in India, so I’m sure there’s plenty of profit margin.
I'm pretty happy with basic 3m sandpaper. But maybe that's why I avoid sanding.
Looks like a deal compared to recent Ebay prices.
Thanks, I had let it slide, I just renewed.
That one is about 12" square. Thanks for the kind words. Here's another one.
https://www.instagram.com/p/CJBhtNfg60Y/?utm_medium=copy_link
I'm having trouble uploading pictures, but here's a link to an instagram post of one of my kumiko panels I made following matt Kenneys instructions.
...
I like Matt Kenneys book on kumiko.
I found I had to widen the slot on a veritas pmv11 blade for it to fit properly in my LN bronze #4.
Love the resourcefulness. Looking good.
Hi,
The cheap side clamp jigs tend to have a hard time holding chisels well, i've read you can file the jaws to hold them better but havent had luck with that. I recently purchased the Lie Nielsen...
Neat project, you dont see finger joints not on the table saw to often.
Great solution, looks nice.
Supply is definaetly an issue. Anecdotally in my case demand has risen a lot too, I've been seperated more often from the fully equipped woodshop I work at and doing more handwork in my garage, and...
Congratulations! Its great to have a marketing team like that.
Pretty exciting stuff. Anyone have recommendations for a buffing wheel for a Rikon 80-805 slow speed grinder?
At least you still got your plane irons to use on stones. Are there any downsides?