Another Question/Problem

I am engraving aluminum flat bar. When the text is normal on my screen the text engraves like I'm looking at it in a mirror.

If I mirror the text as shown in the pic it engraves correctly. I looked thru settings and didn't see anything that I could change to make the engraving look like what I see on the screen.

What do I need to change so that what's on the screen engraves on the flatbar?

Thanks!

F3 button-

upper section, check if glavo 1 or glavo 2 is "X" - It's likely galvo 2-

lower section is the settings for each galvo. There's a check box in each galvo section , NEGATE. If your galvo 2 box is checked, un-check it (or vice versa.)

NEGATE flips the axis...

Quote:

---

Originally Posted by Kev Williams

F3 button-

upper section, check if glavo 1 or glavo 2 is "X" - It's likely galvo 2-

lower section is the settings for each galvo. There's a check box in each galvo section , NEGATE. If your galvo 2 box is checked, un-check it (or vice versa.)

NEGATE flips the axis...

---

I was wondering where you were! I thought that you would know what to do and you were right!
Thanks a Million!