Originally Posted by
Martin Wasner
Mark, Good info on the DC40. I've got one showing up next week since I stole the feeder off of my spare shaper that we use for odd ball stuff to put it on a tablesaw, now dedicated to cutting the groove for bottoms in drawer parts.
What really ticks me off is I ordered two new Steff feeders right after the DC feeders came out. I didn't know about them yet.
I disagree with not being money well spent when it comes to a dedicated setup. Frequently I've had to use a slower feed rate than either what I felt was correct, or the chip load calculations dictated. Being able to fine tune that is money well spent in the long run in my opinion.