Got bored, last night....even though Shop is normally closed on Mondays.....spent a little time in the shop, anyway.....all but the cauls came off the glued up panel, made it a bit easier to move around, and to get my fat body past the bench. Box came off the tablesaw for a little bit. Reset up the rip fence...2" tall collar was judged to be too tall...so..
Attachment 481354
We will try 1-3/8" width....ran all 4 pieces through....best side against the fence..
Attachment 481355
Checked the length of the long sides...trimmed those to match the box, NOT the panel...and, make sure the ends were square. Needed to then move the tablesaw out of the way..
Attachment 481356
And haul this out to where I can use it....set the fence up..
Attachment 481357
Checked the Start & STOP lines on the fence so they match the thickness of the tail board..1st cut...
Attachment 481358
4 at this setting, 1 on each end of the 2 long side pieces...reset the fence a bit, by eyeball (MK II ?) and go again..
Attachment 481359
Ok, all done with the router table, it can go back into it's storage spot, until needed again...Tablesaw moved back to it's "Home Station", box and lid plopped on top of it...
Attachment 481360
Which leaves...
Attachment 481361
Cutting the 2 short ends for final length....stay tuned for part 2, of the Monday Night Follies..