So I got the second leg done, but not without an exciting mishap. After drilling some holes and finishing the plunge cuts with the jig saw, it was on to the router table. I had the pattern stuck to the leg and was making the long cut with a flush bit when the template slipped. I never pin a template because I don't like the hole, small as they are. The bit chewed into the side about an 1/8" inside the line. Very disappointing but maybe I should have known. These are big thick pieces on the router table, so maybe I should have pinned it. Anyway, since this is for my office above my workshop, not for someone else, I moved the template a skosh and yes, pinned the template (hindsight is SO clear) and finished the end. As you can see from the pics, everything except the 1 edge is very nicely lined up. Next will be the bottom, flat stretcher and it's corresponding thru tenons and mortises.
Attachment 391235Attachment 391236Attachment 391237Attachment 391238Attachment 391239Attachment 391240Attachment 391241