Project: Cherry butterfly leaf dinette table

The dinette table in our RV was a really ugly muddy composite surface, and DW asked that I make a cherry table to go with the rest of the woodwork. The original table slid out from the wall a total of 8", and was not really large enough to seat 4. I made a replacement with a 16" butterfly leaf instead of just a pullout, resulting in something that actually works. I had a stainless steel frame welded up to mount to the wall (the original had a square aluminum frame that would not hold the leaf mechanism. The finish is Waterlox. The photos make it look yellower than it looks in real life - it doesn't clash with the existing cherry.

The finished table:
Attachment 464646 Attachment 464647 Attachment 464648 Attachment 464649

The frame and leaf mechanism:
Attachment 464650 Attachment 464651

Finishing (the shop was closed due to COVID):
Attachment 464652

well done ..

What a great way to get a really nice table into a very small space! Bravo on that project!

Beautiful results from a well executed project! Well done Sir!

Very nice table. I really like the gain. I'm curious as to how the table is supported. RV walls aren't generally structured to support a cantilevered table.

Yeah, I was worried too! The original table was screwed to the wall. The walls in my RV (an Entegra) are built somewhat like a house wall - studs with insulation between, and the fiberglass skin fastened to the outside. They are not the typical RV vacuum produced RV walls. The studs are aluminum. There appears to be a wooden cross-piece between studs where the table mounted, and the old table frame was simply screwed into it with lag bolts. I did the same, into new holes. There are 5 5/16" lag bolts holding the table. The table also sits on a cross-member in the front of the cabinet from which it protrudes. That gives it a support point 1 foot out from the wall, so my table at full extension (4 feet) has a 4 to 1 mechanical advantage against those bolts. Thus the use of 5 large ones. The old table had 5 smaller bolts, and extended 3 feet 4 inches. I think I am in OK territory, as long as my wife doesn't sit on the table at full extension.

Very nice work.

Brilliant piece of work, and a beautiful table. Very cool.

Nifty and very attractive too!

I agree, very nice and functional table. Did you design the butterfly mechanism?

John

Yes, after having seen examples online. It was surprisingly tricky to get it to work correctly. You need to get the pivot correct on a left-right axis, such that the entire folded leaf fits inside the frame, while matching the table edges when extended, and you need to place it low enough so that the folded leaf sits below the table. Moving the pivot slightly lets me use the frame as a ramp while opening, so that the bottom folded leaf slides up at an angle and into position.