2 hours went fast...may have put in a wee bit of "overtime" too...Base came out of it's clamps...was trimmed down a bit....then glued in place..
Attachment 426974
And set this aside...then that lid...
Cleaned up, flattened, and trimmed....then added bread board ends....which meant I needed a tongue on each end. Roughed out with the tablesaw, then fine tuned with a Routah..
Attachment 426975
Not much room for error, either...
Attachment 426976
Since the lid is barely 5/16" thick....then a dry fit...
Attachment 426977
And then the glue and clamps, and cauls..
Attachment 426978
Used the #358 Mitre box to trim the drawer fronts to length...
Attachment 426979
Due to the clamps, case is sitting on it's top....
Dug out some molding blanks..
Attachment 426980
Once the clamps come off, I can add a molding around the base..
Attachment 426981
May do a little fancy cutting...maybe add some "feet" in the corners?
And that was it, for today....tried to get a little done..
Stay tuned, there's always tomorrow..:D