Desktop Organizer, March version

Of the one Paul Sellers made....Mine is out of scraps of Ash.
Attachment 454563
Counting the lid, it is 12" long/wide...
Attachment 454564
Sides are 6-7/8" wide, by 5-1/2" tall, counting the 1/2" thick lid..
Attachment 454565
Lid is a glued up panel...the corners were rounded, and there is a finger lift out in front...
Attachment 454566
Was trying to get the grain to flow around the box...came close...
Corner joints are through dovetails...
Attachment 454567
Hinges are brass, from Hobby Lobby. Knobs on the drawer have tenons that are glued into the drawer front.
Attachment 454568
This was merely a way to use up left over scraps from another project....rather than just burn them.

Thanks for looking in:D

Verynice use of small pieces. Will definitely keep the clutter off your desktop. Thanks for sharing!

Nice! I made that project last year. I wish I would have increased the number of dovetails like you did. I like the knobs too. I used a full width drawer pull. I keep sharpening stuff in mine.

Attachment 454586

Boss went to Easter Services on Sunday....and gifted Pastor with this little box......he was quite happy with it, BTW.

Good on you Steven :)