Printable View
I am making a garden gate that will have 3/4" T&G V groove board infil. I am looking for router bits set to cut the V Groove on both sides of board but cant find anything but ones that cut the V Groove on one side. Can anyone direct me to source for this type bit. Or do i have to flip each board over and run thru router with V Bit.
Maybe one of the bits for plywood edge banding would work (with a shallow cut of course). This amana says it has 1" cutting height so it should work with 3/4 stock.
https://www.toolstoday.com/v-9854-55...SABEgJkHvD_BwE
Kinda pricy though...
MLCS has them at a lower price point - https://www.mlcswoodworking.com/shop...band_ogee.html
I have no experience with these, but they were mentioned in a recent Wood Magazine piece on finishing edges on sheet goods.
Just run both faces. I can't imagine that such a bit would have enough buyers to warrant manufacturing.
But Johnny,
Here it is. There is apparently a market for these cutters, or they probably wouldn't make them. I didn't even know that these were available.
David
https://www.mlcswoodworking.com/shopsite_sc/store/html/smarthtml/pages/bit_edgeband_ogee.html
Attachment 418198
Im pretty sure the OP was asking about a tongue and groove with a chamfer that leaves a v-groove between adjacent boards. Basically, this with two faces.Quote:
Originally Posted by David Buchhauser
are most of them with the tongue not centered in the stock? i have not found one that has it centered yet, that you could just flip the board and run it through the same set up.