Printable View
I’m looking for some advice. I need to make three large templates. Each one is about 2’ x 5’. The template will be laid on thin steel and traced around. It might be used several times at first and then may hang on the wall for two+ years between uses. At first I was thinking 1/4” mdf but is there anything at the borg or that might be better or thinner and still stable?
You can get mdf 1/8” or how about using plastic laminate
Hi Dan,
I would recommend Masonite (tempered hardboard) for templates. I have used this material with great success. Approximately 1/8" thick x 4 ft. x 8 ft. for $8.98 per sheet.
I think this would be easier to deal with than mdf, and would probably hold up better with use.
David
https://www.lowes.com/pd/47-75-in-x-...-Panel/3014304
Attachment 414867
I use door skin.
Look for 1/8" tempered hardboard. Both Home Depot and Lowes have it in 4 x 8 sheets, according to their websites.
You are tracing around it, not using it as a router template right?
Make it from something you can fold or roll up for easy storage. I have a roll of brown paper that I might use depending on the precision needed. Or you could use mylar or some other plastic or vinyl. Maybe ask at a fabric store, they use a lot of patterns. I trace with a felt tip pen, it makes a sharp line without pushing the pattern around. Blue tape is your friend.
I regularly cut templates from both 1/4" MDF and 1/2" MDF, many for clients. I think that Steve is spot on that if you can get the thinner 1/8" MDF product, that will be great for tracing purposes, but 1/4" will certainly do a great job, too. I use 1/4" for templates myself for tracing, but 1/2" if it's something that has to be used as a guide for say, routing an edge.