7 Attachment(s)
Trying something...different
Always like to try something new out. Too mcuh of the same old, same old gets stale:rolleyes:
Sooo, I took a couple pieces of 1 x 4x 24" Poplar and cut one down to 12", the other into 6" lengths. Laid out some lines, like always...
Attachment 356229
Set to the thickness of the boards. Marked out a few "fingers' on one face and the end grain. No plan was made for the other face....
Attachment 356230
This time around, I was cutting...mitres..
Well...almost.
Attachment 356231
Version #1.....Something will get changed here, though. I mis-cut the matching half:mad:
Attachment 356232
Soo, back to the drawing board..and Pizza!
Came back down, and chopped a bit more, sawed a bit, chiseled a bit, then a test fit..
Attachment 356233
It is supposed to look like a mitre joint, right? Even on the inside?
Attachment 356234
Until you look at all them squiggles going on.....and then "open" this joint up.....
Attachment 356235
Instead of dovetails and pins...I have fingers. BTW: First time I have ever tried this sort of thing....not too bad, for a rookie?
One done, three to go. Stay tuned....;)