Well....I did have a stack or two of scraps...
Attachment 436645
And a couple of Pine boards sitting around, doing nothing constructive
Attachment 436646
And a couple handy panels of plywood....
Attachment 436647
That needed a job. Sorted through the Ash scraps....had 11 pieces, tossed out 2...They needed squared up, so they were all about the same width, will worry about the ends, later. Process made quite a it of saw dust...
Attachment 436648
Then set up the zero clearance overlay...
Attachment 436649
Used a bit of scrap to center the blade into the middle of the 9 boards...run each through along both edge grain sides....
Attachment 436650
But, height of cut was NOT enough that a pass both ways would reach deep enough.....had to set up the bandsaw...
Attachment 436651
Which left that strip to plane off....later. May change out to a wider blade, later....
Attachment 436652
As I have wider stock to do....at least I have a start.
Seems a couple boxes with drawers have been outgrown. :mad: Will see about a slightly larger version....:confused:
Stay tuned...:D