8 Attachment(s)
Convince me I need a track saw.
Out side of general carpentry, the only use I have for use a circular saw is to brake down sheet goods to a manageable size. And price verses amount of time spent using it determines the cost value ratio. I broke down the two sheets of plywood in about 15 minutes, actual cutting time less than 1 minutes for both pieces. only two 8 foot rips. Having read that a lot of people like track saws to brake down sheet goods. One of my question is how many sheets of plywood do you actually brake down in a year for your hobby? I know I have been woodworking for over 40 years and new things have hit the market I have researched a track saw somewhat and don't see the value to me
One of the reason I am writing this is to maybe help to put out some information that may help a newbie get a different perspective on what is needed to advance in the craft. I feel that we are being heavily influenced by marketing. Rockler has a small parts tapering sled for sale for $79 and some change and the sled I do straight line ripping is the same sled or principle.
Attachment 460573 Attachment 460574 Attachment 460575
I built a little clamp on table to help hold and support long boards when cutting at the table saw. Take the four pieces of plywood cut in the pictures above, I ran each through the table saw with the factory edge against the fence. Then the cut edge against the fence to get rid of the factory cut. ( I had a little extra to cut off) Now if I wish to brake them down farther I just adjust the rip fence. Cross cutting is a different animal and can be a later topic.
The next pictures just happen to be a sled and a straight line rip on a piece of hard wood. The saw mill I get my lumber from doesn't straight line rip. For me it is a safety issue, I like a straight side against the fence for any other cuts in the board.
Attachment 460576 Attachment 460577 Attachment 460578
Other uses of the infeed table
Attachment 460579 Attachment 460580
On lumber that I straight line rip I prefer to cut them into shorter lengths with a battery saber saw.
Also I can flip the sled with the board over and use a router with a pattern bit to finish the edge on boards that are to lone to straighten effectively on a jointer.
I showed here my solution to the things I struggled with for years. A torsion box cutting table with fold up legs. No longer do I have to get on my hands and knees to cut plywood. I can put a sheet of OSB on it and I have an assembly table. My wife just used it for a garage sale. I have a couple of small block that are the distance from the edge of the circular saw to the fence to I can accurately position the fence to my cut line.
I thought I would also mention that I can do plunge cut with a circular saw so it is not a good reason to go to Menards and buy a cheap $100 track saw.
And lastly Blue Spruce has a 4 inch sliding bevel gauge on sale for $119.99. Can throwing money at a hobby elevate your skill level? I some what view a track saw along those lines but I think very handy is space is limited.