Originally Posted by
Jim Becker
Alan, if you need to get the bandsaw off the 4x4s, just do it in steps...pull it away from the wall a little, raise the back with a jack or lever, remove the rear 4x4, let down the back side (the wall is there for safety), raise the front, remove the 4x4, lower the front and then wiggle it back into the desired position. That said, if the table height is acceptable with the blocks in place, leave them as it will allow for easier moving of the tool in the future if that becomes a need.
That floor looks great. Can we assume the glue thing is because it was covered in carpet at some point?