Unisaw motor hums but won't start
have a 3hp Unisaw that suddenly stopped working. When I push the switch to start, I hear the motor humming, but the motor doesn't start rotating. I can easily rotate blade by hand and see the belts rotating the motor pulley. Any ideas on what the problem is and what I would need to do in order to get saw working again?
More help- where is centrifical switch and capacitor?
I took one end cover off motor ( opposite pulley) and found just fan. There is another cover on the same end that is held by two nuts that come out from parallel to the motor. I didn't want to tackle taking these nuts off without checking to see if this is correct.
(note- I have 80's model unisaw model 34-802f)
Unisaw start capacitor -wiring order
My saw was not starting-just humming. Found problem was start capacitor wire was broken. I took the capactior out to clean sawdust caked in the housing and now am not sure if it matters which of the two wires goes with the capacitor ends. Does it matter? ( one of the wires is gold).