http://i.imgur.com/Icg5ll.jpg
Trying to figure out how much HP it has and if I can set it for low RPMs. I'm pretty sure I can fix it up.
and this is its current condition..:confused:
http://i.imgur.com/SwePtl.jpg
Printable View
http://i.imgur.com/Icg5ll.jpg
Trying to figure out how much HP it has and if I can set it for low RPMs. I'm pretty sure I can fix it up.
and this is its current condition..:confused:
http://i.imgur.com/SwePtl.jpg
What's on the motor plate? That should tell you the HP that it came with. You can measure the pulleys and determine the drive ratio. Use that and the motor RPM to determine the lowest and highest bit RPM.
Good machine, I have 2. Came with .5 HP and 4 speeds ~250 -~1100.
Had mine reworked.
I have that same drill press, manufactured some time in the early 70's. I think mine is 1974. 4 speeds/pulleys, but I am not at home now to check the motor HP. Good drill press but no hand crank to change the table elevation. Have to use the muscle method; not fun with my auxillary table mounted on it. Yours should clean up nicely and work great.
We used to have one just like that where I worked. IIRC it had a 1/2 hp motor. Good machine! Sure would be nice if it had a crank up/down table. That thing's murder on your back.
Anyone know what its worth?
That's a nice find depending on price of course. You can shop-make table elevation schemes from simple to complex, it just depends on time and money- what doesn't?
Here's a couple of links to review for ideas:
Also, a used car jack, the scissors lift type can be employed as well.
Don't forget too, you can use a jackshaft combo to get the speed range anywhere you want it to be.
- Beachside Hank
Improvise, adapt, overcome; the essence of true craftsmanship.
It looks to me like the mount is missing from the motor. If so, you will need a motor for it. I would also find out if it comes with the 4 sheave pulley for the motor. Those can be rather pricey.
John
Here is another pic of the motor.
http://i.imgur.com/3KKcZ.jpg
That motor sits in a cradle mount. The cradle is missing. You will need a cradle or a different motor. I'm guessing the step pulley is missing, too. Keep these things in mind when determining a value on the drill press.
John
Looks to be a 15-081 model.
Here are a couple more like it:
http://vintagemachinery.org/photoind....aspx?id=12217
http://vintagemachinery.org/photoind....aspx?ID=13592
http://vintagemachinery.org/photoind....aspx?id=14163
http://vintagemachinery.org/photoind...l.aspx?id=9249
What it is worth ultimately lies in what you want. I prefer old iron to the new stuff for the most part. If I planned on keeping it long term and it was a good drill press, up to about $275. You would likely spend another $200 or so going through it and setting it up well. There are few, if any, drill presses made today that would stack up to it, especially for less than $500 and a bit of time.
Here is a restoration of a very pretty drill press:
http://vintagemachinery.org/photoind....aspx?id=13775
This design you are considering is the "split head" and consequently desirable.