5 Attachment(s)
Issue with table beds on Delta 6" Jointer
Hi
I have a Delta Model 37-190 Jointer and am having issues with the beds being out of level wrt the fence. I am the original owner. When I set the fence to 90 degrees wrt the in-feed table, the out-feed table is no longer at 90 degrees to the fence. I've attached a few pictures of this issue. The only basic adjustment I see is the height adjustment of the out-feed table.
The pictures show a square on the in-feed table with it set to 90 degrees (no gaps) and then I put the square on the out-feed table with a gap near the bottom. I did the same experiment with my Wixey digital angle gauge and zero'd it on the in-feed table and then it shows that the out-feed table is slightly tilted.
I am not seeing a way to resolve this and wondering if anyone knows how to resolve this. Are some sort of shims needed?
thank you,
'mark
Attachment 518003
Attachment 518001
Attachment 518002
Attachment 518000
Attachment 517999