Speedy 400 Laser Firing Problem
I have a weird one, we got a speedy 400 w/ 80w iRadion tube. The tube was only firing at ~26w so we sent it off to evergreen to be recharged. I got everything recharged, reinstalled, and aligned but the laser is having a very odd issue. The weird part is the tube is not firing unless its at 100% power & <70% speed, otherwise there is nothing. I.E. if i were to engrave at 75% p and 70% s, the output that I see is 0% p and 70% s, but if i crank it up to 100%p and 70% s, its very clearly working.
Here is what I have tried/observed
1. The lights on the laser tube are flashing when it's suppose to be lasering.
2. I have rebooted Ruby and the machine and the same result is happening.
3. I tried calling Trotec's main line, no answer, i left a message.
4. I tried texting a Trotec tech I have worked with in the past, but haven't heard back yet
Next Steps
1. Try on Job Control, just in case Ruby is bugging out.
2. Try another design, though this wouldnt make sense as it works fine at 100% p.
3. I might try to reflash the most recent firmware, eventhough im pretty sure it already has the most recent.
Suspicions:
1. I wonder if after having the tube recharged, if the tickle power changes or any of the service settings??? As the lights are flashing on the back of the tube.
2. It could be a ruby bug, but i just dont think so as the lights are flashing properly on the back of the tube.
3. ???
Any ideas you have please let me know.