I have the table off of my old Delta 10" cabinet saw and thought it a good time to give it a lube job. I have a can of WD-40 Quick Drying Silicone, but thought there might be a better choice. Any thoughts/suggestions most appreciated. TIA, Vince
Printable View
I have the table off of my old Delta 10" cabinet saw and thought it a good time to give it a lube job. I have a can of WD-40 Quick Drying Silicone, but thought there might be a better choice. Any thoughts/suggestions most appreciated. TIA, Vince
Why not use grease? It will last a lot longer, stays put and is generally preferred if you're not in a high-temp, high-speed application. At least that's my opinion.
I took mine apart a few years ago. I used graphite, dry lubricant.
WD-40 can be used as a cleaner. I would advise taking a tooth brush and clean out all the gearing. Then re-apply white lithium grease for lube.
I like Dupont chain saver lube. Goes on wet and dries to wax. Does not attract dust.
BilLD
Paraffin is my first choice in this application, white lithium grease is a distant second. The only thing I'd do with the can you have is get it far, far away from my woodshop. Silicone doesn't have any place there.
I use dry graphite lube.
I use paste wax applied with an old toothbrush.
Ken
You want something that doesn't hold sawdust. Paste wax has been a longtime favorite lube for low speed applications that doesn't attract and hold saw dust. The last time I lubed my table saw I used Tri Flow Teflon Lube. It goes on as a spray and dries so doesn't attract sawdust. At the time it was a DuPont product and was considerably less $ than what's on Amazon today.
Paraffin has more staying power than Wd40 or paste wax.
Lots of good answers. WD-40 is rarely one of them if the need is long term lubrication under pressure:). I switched to marine grease years ago. I just did a maintenance run on my Saw Stop and everything was still well lubed. I cleaned everything out and re-lubed since that was why I was there :). An approximately 12oz can of Sta-Lube
Attachment 507364
has lasted me for years and will probably outlast me. I slip on latex gloves, add a dab with a Popsicle stick and rub it along the threads or ways to be lubed. Operate the mechanism once or twice, wipe off the excess, and you're good.
Attachment 507365
This picture is before running the mechanism and wiping off the excess. Do not leave this much grease on your machine :D:D:D.
Do not leave this much grease on your machine :D:D:D.
Glenn
the XO on my submarine used to say, "grease, dust, and time, make a very good glue."
About an hour later we would cleaning and polishing Zerk fittings and actuator sleeves.
Note for Non Americans, Paraffin means solid petroleum wax not liquid kerosene.
Bill D