-
5 Attachment(s)
DeltaX5 Table Saw Switch
Hello, I am new to the forum and I am having a problem with my on off switch. I have a Delta X5 3HP Cabinet saw. I bought the top half of the switch and wired it. I must have copied something wrong as the pish button on the switch doesn't have power to it to engage and hold the switch on. I can manually push the contact to activate the switch but the button doesn't do it. Attached are pictures of the wired switch. Can you see what could n
be wrong? Thank you in advance. Richard Sichak
-
There should be a wiring diagram inside the cover.
-
Agree with Mike, look for the wiring diagram inside the machine. Also, the part you have in the pictures is called a contactor, not a switch.
-
Looks like terminal 3 (L2 along the top edge) is wrong. You've got it hooked to one side of the coil, but it otherwise doesn't go anywhere.
-
Single or three phase. Make sure the coil voltage is correct. Check the off switch has continuity.
Bill D
-
-
Ok thanks on the contactor (switch) terminology. I will look for the diagram. Thank you.
-
-
Thank you, I will look for the diagram inside the cover.