Printable View
This is my first post but I have been lurking for a long time...this is a great forum.
I need to retrofit some damaged drawer slides. The drawers need side mounted slides that will fit in a 7/16 gap on each side between the drawer box and the case. The damaged slides had no markings on them and I have had no luck finding replacements that will fit.
Can anyone help with a source?
Thanks,
Mark
Would these work for you? http://www.leevalley.com/US/hardware...614,43616&ap=2
Jamie, that is the general idea but I have no way to add the rebate to the drawer sides. I need something rated at 50lbs at least.
I appreciate your help.
Welcome to the creek.
Just a thought, could you rout a 1/16" dado in the drawer side and then go with 1/2" slide?
wwhardware or rockler
Those slides are 3/8" thick. You'll actually have to shim them out to make them fit your 7/16" gap.Quote:
Originally Posted by Mark Donnici
Can you just run the drawer sides over a jointer or through a table saw or sander to gain 1/16"? You would then have the option of very many side mount slides that only require 1/2" clearance. It's a work around but might be worth the effort. Bill's idea to make a dado should work too. Maybe just run the drawer sides over the table saw to take out a 1/16" x the height of the intended drawer slide.
I did some just like Sam. Cut 1/16 or a hair more off the sides of the drawers. Just set the sawblade a bit higher than the slides are high. It worked great. Of course, this assumes you can get the front of the drawers off to make the cuts.
I won't say why I had to do this. Lets just say it was my first time with drawers.
Rick Potter