2 Attachment(s)
Cutting 45's on an Incra for a 46" square frame
I doing a test to determine if i can get this miter tight. I don't cut a lot of miters so... Using an Incra sled that is 90 to the blade. Then set it at 45 degrees. I tried a couple sample cuts and this is the closest I can get to 90 degrees on the miter corner.
Width of pieces is a little over 5". It is enough out of 90 that if I push it into 90 it open up the miter at the outer corner. Not sure how to adjust for this? Thanks. Brian
Attachment 519063Attachment 519064