Short Stroke Sliding Table Saw or ?
I recently sold an asset that will allow me to upgrade my table saw, so I'm trying to decipher the market.
My older Grizzly Cabinet saw, with an outfeed table occupies a 5' square space. Additionally, I have 9' on the operator side for ripping 8' stock. I have to open the doors on the outfeed side to rip anything over 7'. The existing setup sits with the left side near a wall.
After spending several hours, it seems that it is impossible to figure out the space a slider actually takes up when not in use. Perhaps I'm just too unfamiliar to understand the terminology, but I simply can't seem to locate the info.
I'd like to have a minimum of 25" rip capacity to the right of the blade, and a minimum of 5' cross cut length. I'd need enough slider travel to cross cut 25".
Does such a beast exist?
Would a slider attachment on my existing saw allow the same?
As I see it, adding to my existing saw leaves me with all the same drawbacks (poor dust collection, no riving knife). If I can fit a slider into my shop will it address these issues?
Thanks for your insight.