This is very real. We were staining trim for a new house outside before installation. There was a brick pallet laying in trash pile. Stood it on edge...
The OP said the cut always goes to the right. Can probably rule out grain. Must be technique. Some how warping the plate. Maybe placing a board flat...
I use the slitter to cut stringing and straight cuts for fretwork. I have also used it to split long dowels for various trim pieces. I find it useful...
I think my LV rabbet jack is my favorite. It’s a little big for some rabbets but for those 1” and larger wide ones it is an absolute joy. Because it...
This type of work is exactly why the Stanley #75 was made. The iron set flush to the sole and that gap at the nose is supposed to be there to go over...
I like stencil brushes. They are fairly cheap and come in different diameters. Sets of five are available. You can put a small rubber band around the...
Lifetime woodworker. Now retired. Raised in Washington DC. Viet Nam vet. Married with children and Grandchildren. Registered here in 2012 could not participate much because of back issues. I had surgery and have a spinal cord stimulator implant. I have been able to get back in to woodworking and hope to participate more.
Location:
Missouri
Interests:
I like to build furniture. I used to hunt and fish a lot but no more. I have a CBR as a service dog.
Find latest posts
View Articles
View Blog Entries