Doug Garson
Member

And some would see not reporting as gang/mob/mafia behavior, wonder which is worse?

Are you using the correct screws for the type of wood? Hardwood screws don't hold well in softwoods.

How about renting one of the trailers used for construction site offices/lunchrooms etc. They would be insulated, heated and air conditioned.

I don't understand why anyone would use a handheld grinder with any type of wheel to hollow out the underside of a cutting board. A router bowl bit...

I would use a router bowl bit like this....

Rod is that an issue with a home shop or just a commercial operation? I see the potential issue if you ever had a fire that started from a fixture...

It looks like you replaced the shopvac barrel with a plywood box. What does the box do that the barrel doesn't?

One additional factor I took into consideration in my decision was the cost. Because of my strong prescription my glasses were expensive and as my...

The website on the banner just takes you to the Hitachi tools available at Lowes, no mention of Metabo that I can find.

Curt, I assume it was the glaucoma procedure that caused the "looked like she'd been in a fight" my cataract surgery was totally painless and I had...

I occasionally suffer from dry eye, can't say I noticed any difference post surgery.

It's a personal decision so only you can decide. I wore glasses from age 12 to about 8 years ago (I turn 70 in March) when I had cataract surgery and...

Looks like Art beat me to it. It will be interesting to see how Craftsman sells at Lowes. It's been years since Craftsman was seen as a quality...

To answer your other question, yes probably hundreds I have a shaw.ca (my ISP provider) account and an outlook.com account. There are also yahoo...

You could even make the sample with cardboard to verify the angles. Not necessary, I'm sure the above answers are correct but may give you more...

OK, looking at photo #2 it appears to have a gear shaped locking knob on the front facing handwheel, not the original but might still be functional....

Maybe post some pictures of your router & template and the finished product. Most likely it is just a matter of practice.

^^^^^^ what he said, well done.

I thought the issue was missing parts not non original parts. If the question was "is this a good saw to restore to original factory specs" the...

OK, I'm curious, what are all the parts missing from this saw? Miter gauge and nameplate..................?

Would it be worth your while to build an enclosure around the motor with a small heater for the winter?

One trick, you may have already thought of this, is to clamp the boards together face to face so the fingers line up. This makes it easier to apply...

So essentially you are setting the fence and mitre slot to be parallel to the direction the blade cuts not necessarily to the blade itself unless the...

What method do you use to adjust the mitre slot and fence to be parallel to a 1/4" band saw blade? I understand how you do it with a 10" table saw...

Great idea Dan, here's a video for a simple jig to pattern cut on a bandsaw. https://www.youtube.com/watch?v=wycIJa-T-Oc

You lost the spring and don't remember from whom or when you ordered the replacement? Quick, check to make sure you remembered to put your pants on...

Why not attach the pattern to 1/8" mdf or plywood, cut just outside the line and then sand to the line. Then tracing the outline on the work piece is...

Forgive me for being confused but wasn't your original post "Using anything other than the fleshy tools God/Yahweh/Allah/Buddha/Zeus/Mother...

OK, but going back to your original post, we're all cheating because I don't know anyone who limits their woodworking to breaking sticks over their...