Jim Becker
Moderator

Yea, my kitchen lower cabinets (and the pantry cabinet I just refinished) have ProClassic on them...all brushed since it had to be done in place for...

Dennis, those benches turned out very nice from the photos I saw! 'Glad your son got some leave at home, too. This past week in the shop I did...

I'd consider using filler strips/edge treatment and work out a way to make this a "feature" as an alternative to making all new drawer fronts.

On a typical North American style table saw, regardless of size, etc., most folks will likely use the left slot with the off-cut to the right....

I don't believe that you're going to be affected for this kind of projects by seven thou....especially since material is variable in thickness. I do...

LOL...my nemesis for many years.

The Raptor gun is what I'd use for this kind of application...I"ve actually considered buying one for use on my CNC for hold-down situation to back...

Try it without glue. If it's solid...be done with it. If it rocks (assuming you have things properly leveled with the floor), then glue them. :)

If you are going to use an existing outlet that happens to be a higher amperage than required, then replace the plug on the saw (if it even comes...

My thoughts are along the same lines as you...the shelving hardware goes on something removable. That applies whether you use bi-fold doors or you...

The $6 a year Contributor membership helps keep the lights on here. It also gives you access to the photos, private messages and Free Classifieds. ...

My suggestion then would be to remove a longer strip of drywall over the stud so you can fasten it back properly with screws and then do the mud...

Please click on the Donate button up above and become a Contributor which gives you access to images, private messages and the Classifieds, etc. $6...

No experience, but I'd be very, very surprised if the new saws were anything less than the previous, given that SCM/Minimax has built a strong case...

I honestly don't know the answer to the question.

With those supports indexing into the double stretcher at the top like they do, I think I'd actually not glue the table supports...just do the screw....

The only place you will not be using glue for sure is between the table top and the base...it also appears in that plan that the horizontal table top...

Short cone cyclones don't typically separate as well as long-cone designs, but almost all of the smaller, wheel around cyclone setups use that design...

Some structures in some settings can function well without gutters. In the instance of doorways and walkways, deflectors can be used to re-direct the...

I would have loved to have seen that tree...3' diameter of that particular species must have been a sight to behold. Around here, it's rare for...

Given having the available principle earning money through investment, I'll suggest that it would last a lot longer!

The auto industry theoretically has the ability to "embrace the rainbow" when it comes to colors with the automated paint systems they now use, but...

With no venting, it's critical to use an insulation method that is designed for that situation to avoid what can be serious issues over time.

I don't do videos but will admit that sometimes I just want to watch the tooling make the cuts and "conveniently forget" to put on the shoe for...

Like Prashun, I'd likely do a lot of charitable activities.

The vertical fixture is something you alway want to have if you are going to use a lock-miter bit which incorporates the 45º angle but with a kind of...

While I use my CNC for this kind of thing normally, for those times when I've put dog holes in an existing bench, I used a combination of a Forstner...

I recently bought an "inexpensive" monitor from a Chinese company called Bangood after someone mentioned a sale somewhere here on SMC. It's one of...

If you leave things quiet overnight or for a day, you should be fine after a deep cleaning. Using a fan to blow air outside while you are cleaning...

Truly fabulous!!