Jim Becker
Moderator

Bill, I have never, ever seen a "grass board" use on any kind of fence in this area and that's living here since the last year of the 70s. It must be...

In my jurisdiction, fences require a permit, can be "on the line" (although I put mine on the side 2" off the line) and there's no rules about "good...

John, I hope the surgery "does the trick" for sure!

That's good...here, they have only had some forms of "knock off" connectors. I ended up buying off Amazon when I needed them for the shop build.

I've come to learn over the years that sometimes travel time is just part of the cost of getting the right material for the project...and the right...

You apply the bead to the edge of a wider board, using whatever method you deem appropriate and available and then trim off the excess material.

Different species of wood have "popularly waves" that are just a natural part of how society seems to work when it comes to aesthetics. Cherry is...

The sad thing is actually that some folks would pay the invoice...

Sounds interesting, but I'm not a machinery guy for the most part.

There are very thin sawblades on the market that are typically used for cutting fret slots. Using or adapting one of these with a "micro table saw"...

Both are absolutely beautiful!

Yes, that is a feature of some vehicles. It is also sometimes on a vehicle version sold in other geographies but not on the vehicle version sold in...

These are small tractors and that kind of feature isn't really a thing, unfortunately. Some folks will relocate the fuel filter and sometimes use a...

My CSX-18 came with the same organizer lid and I've already taken advantage of that when I was at my daughter's apartment to assemble a new bed frame...

Alas, that's not a thing with many subcompacts that utilize blow molded tanks that are complexly shaped and generally live under the seat, draping...

When that's happened with my Kubota BX22 over the years (same HP engine) it's generally been in the fuel system...debris or bad fuel. Clean/change...

Steve, I've been buying from Hearne for many years now. My cousin's son even worked for them for awhile. I've never had an issue and enjoy my twice a...

While I would like to make a simple answer to this, I can't. Historically, I only used BLO on work surfaces because it was easily renewable. When I...

While a lot of folks associate Systainers with Festool, it's important to consider that a number of other tool brands, such as Makita, also use the...

I consider Frank Zappa a "musical savant" when it comes to both composition and performance. It was a sad day when the world lost him.

Hearne Hardwoods is one good source.

To clarify, this is plan dependent, although it's a common feature to have discounted HA benefits. Medicare Advantage plans often also have vision...

$13K for hearing aids, unless they are something really special like the implants Ken has, sounds over the top. But there are big markups out...

That bench and storage setup is the bee's knees, Michael!!

I actually spent quite a bit of time in the shop this past week which is a trend I'm liking very much. Much of that time went to creating a...

The OP is not going to be able to answer you as this thread is from 2010 and they are no longer a member of the SMC community. Bill's and Edward's...

Yes, you are missing the "+Post New Thread" button near the top, left of any forum discussion area.