Jim Becker
Moderator

That turned out well!!! And it's a very useful file, too, as there are always "those times" when a fresh insert is just the ticket for a particular...

Truly beautiful doors!!

Steve, I hit a nest with the FEL a number of years ago at our old property and had to "run for my life". The little Kubota was still running for...

Yea, the triple chip blade and a fresh zero clearance table insert can do a nice job for occasional cutting of chip-prone materials for sure.

I'm not familiar with the Grass, but IKEA has used the metal Blum drawers in cabinets I put in the laundry at our old property and they were really...

As long as the sound level is acceptable to you and you can easily turn it off and on, it doesn't seem like a bad solution outside of possible back...

Adding to previous commentary, with the limited depth available in line with the cutting blade on a cabinet saw, it's a lot harder to have that...

Aaron, 475 CFM is about what a 4" port can actually support at the average velocity achieved, regardless of what DC is being used. Oneida works hard...

Congrats on the new saw and getting it in the shop! Not sure I'd put the weight, etc., of that 4" hose on the blade guard collection unless it was...

Same, although I doubt I'll ever enter and my instruments so far are not anything as advanced as yours!

That's a great build, Matthew. I enjoyed the video for sure and it's clear you put a lot of time into your design. The use of the CF was really...

I can see zero sense in the insurance company being concerned with a minisplit...it's a modern, efficient and very safe heating solution that's used...

I had my Rotex 150 repaired a few months ago...and in that case, it was worth it for sure. I think you made the correct decision, Cliff, based on the...

^^ This....for sure.

POP is a "one device" email solution and all messages that are downloaded to the local client are no longer in the email server "out there". IMAP...

Bill, I have not had a vehicle in a decade and a half or more that did not have heated seats and a heated wheel. None of them were Volvos. These are...

Factory finishes are not done with the kinds of stains, etc., that are typically premixed at the 'borg. The "colors" are not standard things and just...

Yea, with the scope method, surgery seems to be less consequential because what you see is so inconsequential, but "inside", there's the same level...

Agree. I wish I would have had a grapple at our old property over the years...it would have got a lot of use for sure.

Tom, Centauro was the OEM manufacturer for the SCM/MiniMax machines for many years (with the exception of the S45N which was made in-house) and the...

I hope you heal quickly...but definitely take your time before you exceed the limits your doctor left you with since you might feel better fast, but...

If it's not honoring the flat depth, the first step I would do is delete the toolpath and recreate it. This eliminates any glitch that might have...

General wear and tear, Maurice. I had the left done in about 2017 and was told then that the right would need to be attended to at some point. I put...

I agree, Keith. Even though I use the Big Orange Power Tool a lot less here at our downsize property, it still provides utility and helps with a lot...

It did wander, Dennis, because it's potentially material to the solution, although not the only factor. Do you have public or private water? It seems...

That's a very nice tractor, Greg!! Congratulations!!

Yea, there's a lot of "splash" that comes off the blade due to rotation and what get's caught in the gullets and that's what an overhead collection...

Operative word is "may", Dan. Some solutions may not be suitable for public pressure/sizing. For anything like this, checking the specifications is...

True, but there are also trade-offs!!