Jim Becker
Moderator

We finally just got a break from the excessive humidity and that should hold through the week. There's also an upper level low that will be sitting...

Looks like it was wired with a common 3-wire dryer plug to match whatever receptacle was in your previous shop. Base on your photos, it's actually...

While I prefer a wider arrangement as comes with a J/P combo, I'll echo what Glenn just mentioned...pick something that's available as there really...

Change your bookmark for the site to "that page" after you do the click on the logo, etc.

Send some here, Alan. I'd be very happy to take a third of that from you at the moment...it's very "crispy" walking outside right now...

If I'm not mistaken, the rails on the PCS out in my temporary shop uses a 2x3 format. I measured it with the intention of buying some steel to make...

Today was drawer day...which started out with a little "shopping" in the shed After cutting two pieces of leftover QSWO 12.5mm plywood to...

Aaron, there is an extensive plan for sound abatement in the new shop building to be implemented and yes, some of that will be focused on the G700...

That's interesting considering it's sold as paint thinner and many of us also use it for cleaning because it doesn't leave a film behind like...

The only two options I would entertain for this would be to either rewire the circuit properly for four wire 120/240v operation per code or replace...

Clear the existing sawmillcreek.org cookie(s), close the browser completely (and consider rebooting the machine and then start the browser followed...

Yes, initial cost is high, but after a few years, things will balance out a bit more and the quality of the veggies takes the rest of the pain away!

That extra mass isn't hurting you in the "runs smoother" department, for sure. 'Glad it's working out!

Construction lumber, in general, is coming down in price across the board, but some of the anomalies we might see out there in the home centers and...

That may not be true for the portables that the OP is considering, at least yet. Cordless tools have very much gone that route, however. ---- ...

No experience, although I actually touched one years ago. They were a decent dedicated resaw machine back in the day.

Bryan, no, I'm not up for doing my own spray foam other than corner sealing. I'll get some more current quotes, however, once I'm closer to build....

Steve, I don't disagree with TWW's logic on that...a whole bunch of cross cutting really is at 90º in my experience, so a fixed fixture, as it were,...

I've been thinking about the same thing as I visited this thread each day to see what folks have been saying. I suspect that a digital scale would be...

As decent and capable that Mach4 is, Acorn is very much next level, IMHO. It's nice that the option is there to folks to do an upgrade like that.

Yea, it's not something that might be immediately intuitive, but scoring capability can sometimes be a "problem solver" and I'm looking forward to...

"Old stock" can do that sometimes, even though Zinsser products do seem to have a reasonable shelf life. 'Hope the uber-thin coating resolved things...

Mike, while I don't use scoring the majority of the time with solid stock, I have employed it occasionally for something that it was critical for me...

That was likely a very good choice for this application...designed for the task for sure.

I"ve only had a cabinet saw in my (temporary shop) for about a year right now and I had to nearly immediately make up a crosscut sled in order to...