Jim Becker
Moderator

That looks really nice, Mike!!!

I already bought a mixer...for a lot less that renting something would have cost around here and with no time limitations. $219 vs $90 a day! I've...

I agree with this method...it's likely the best solution this side of remaking things.

I'm fully prepped for the walkway...that was the "easy" part. As you might notice, I managed to find a way to use the CNC machine to support this...

As I've said multiple times...there is a barcode on the ballot.

Like I said previously, the ballots have a barcode on them and the system prevents someone from voting twice.

Once you decide on your pricing, you can put your ad in the Classifieds. I moved this here because discussion isn't permitted in the Classifieds. ...

That type of building isn't as common around here, at least in residential settings I suspect. I don't see any issue with the method you plan on...

Congrats on your twenty, Dennis! Looks like I pretty much share that milestone with you, at least relative to time putzing around here. There's a...

For the workbench I certainly wouldn't because..it can cause interesting problems when locating things like additional dog holes, etc., in the...

Stunning!!!! And that's because you took what was already a great piece of workmanship and kicked up a whole bunch of notches with that "mistake"...

Brian, are different setups for straight real estate equity loans vs a home equity line of credit when it comes to terms and sometimes things...

Once small point, David, your birthday can matter on this as folks born after a certain date have to wait a little longer for things to kick in that...

I suspect it has the potential to be higher since the experiment was shut down after x hours rather than letting it continue all night.

I made some inserts from HDU (sign foam) scraps while still at the old shop to hold some smaller items and hope to do similar at the new shop as I...

A mess waiting to happen? :D

Congrats, Brian! Nothing like a new tool to spice up one's life!!

He specifically mentioned that he used those because they were what is very commonly used in folks' shops. My shop has two of them, as a matter of...

You are likely in "computer view" (full) mode rather than "mobile view" mode. The latter is easier to read, but has limitations on what you can do,...

Yes, the resource I was trying to get out was set up specifically for slabbing. I was really, really, REALLY disappointed that it didn't happen as...

I've broken more .25" shank tooling than .125" shank tooling on my CNC, but it's always human error that causes it. :o

Yes, it's standard because you are borrowing based on the value of the property for the HELOC and the property is therefore, securing the lender for...

Heat. Turn a wooden caul on your lathe to match the diameter of the inlet you need to get your plastic pipe to fit over that has a short flat spot...