Steve Smith Springfield
Member

:( Now I know I’m being watched :rolleyes:

It cost me $300 to freight ship a 700lb 48x48 pallet 6.5' tall and a 580lb 4' tall 48x48 skid from california with business pickup to a local...

You cover every single thing you do not want foam on. It goes everywhere. We covered the walls and garage doors with big plastic - It was still on...

$17 ea is what they were new. Id go $15 ea.

Soo nice!!!

Yes sir. 12x24 8' tall Mezzanine will be next Major shop add.

Blocks and fittings.

Change the rear destaco clamps to a bimba air cylinder and foot pad. Kreg used to sell that conversion for the k2.

If its light just start with wd40 and green scatch pads under a ros.

Grounded 3prong plug on opener? Try plugging it through a decent power strip that has some filtering and see if the behavior changes. If its dead...

I put two disconnects off my meter base when I upgraded to 400amp in 2013. One for the house and one for the new shed. That way when It came to do...

I just ordered mine for $722 sure you don’t need a second one? 😉

My buddy just reminded me I need a lot more stuff. Any suggestions on chisels and sharpeners? And what ever else...... I have a DC, ts, bs, dp,...

Cv rated for uv light exposure outside?

Thank you! Thank you! Thank you! Thank you! Thank you! I ordered it for $722. I owe you a hug 🤗 or something for the heads up!!

Planer should be closet to DC not furthest. Get the Jointer and planer closer. Id move shaper after that if its big and gets used. Also planer...

It’s definitely worth waiting for then.....

I use my Festool tracksaw to get that straight smooth edge. If shop space is an issue then seriously consider this as an option.

Very much so Jeff! Started the air line on the north wall today.

I have a G0638 10hp cyclone and it electronics are super nice. It has a programable timing start circuit, remote start, multiple contactors for the...

I am sure if I had an inspector for my shed they might have an opinion.

Anyone else care to comment? Grizzly is 500 and the Jet is 850. Grizz is 3/4 hp and Jet is 1 hp I’ve got both brands in my shop

Get a foreman. Bee's knees.

Wood and wwj for me. I like $10 sub not $32.

Walls are installed. North wall air lines go up tomorrow

There May be a min order, but more importantly whats the minimum return amount lol.

I too am looking at the Jet 1221 and Grizzly G0844. What did you decide on?