No Recent Activity

4 Visitor Messages

  1. View Conversation
    Thanks for letting me know as I forgot to look.
  2. View Conversation
    Jim, I had Jack Morse help me make these and they work well. One 4" and one 6". When you do a lot of ornament work, it is amazing how often you use both.
    That said, I looked closely at the Robust rests at the AAS symposium and believe them to be superior. Cost if very reasonable. If you needed two, making them is probably a cost effective option if you like making tools or have a handy friend that does. But one? Go for the Robust rest. I wonder if anyone is selling them at the Woodworking show in Atlanta to save the shipping?

    Mike Peace
  3. Mike,
    I'm thinking of this thread right here, where you posted a couple of pix showing your loaner mallets for you classes.
  4. View Conversation
    I'd be happy to, Jim. I make a couple of different styles so you need to tell me which one you're thinking of, but all of them are about 10.5" to 11" long. The head (from the end to the narrowest part of the handle) is about 5" long - the handle makes up the rest. But that dimension is approximate - sometime it's a bit more than 5". The biggest part of the head is about 2.5" in diameter. That changes depending on how heavy you want the mallet to be. I do the taper to the small end of the head by eye - I just cut until I think it looks right. Eyeballing a couple of my mallets, the small end is about 2" or a bit more than 2" (definitely not smaller than 2"). The handle is really "to fit". The best way to size it is to cut the basic shape and make it too big. Grab it with your hand (while it's on your lathe but not turning - but if you want, take it off to get a better feel). Go back and trim some more until you get the shape and size you want. I found that it took me several mallets to get a handle I liked. And I had to use the mallet for a while to decide if I liked it. If you start with a handle that's too big - and you leave the center point at the bottom of the handle - you can put it back on your lathe by chucking the head in a chuck and turning down the handle. If too small, you have to make another mallet.

    Good luck! If you encounter any questions while you're doing it, please contact me.

Showing Visitor Messages 1 to 4 of 4
About Jim Underwood

Basic Information

About Jim Underwood
Making stuff
Cabinet Designer/software/hardware support


CarveWright Model C
Stratos Lathe
Jet 1014


Total Posts
Total Posts
Posts Per Day
Visitor Messages
Total Messages
Most Recent Message
05-18-2012 9:15 PM
General Information
Last Activity
Yesterday 12:08 PM
Join Date
Home Page

6 Friends

  1. Bruce Kinney Bruce Kinney is offline


    Bruce Kinney
  2. Chris Woodall Chris Woodall is offline


    Chris Woodall
  3. Lawrence Richards
  4. Mike Peace Mike Peace is offline


    Mike Peace
  5. Rob Price Rob Price is offline


    Rob Price
  6. Steve Mellott Steve Mellott is offline


    Steve Mellott
Showing Friends 1 to 6 of 6