Michael, can you post a picture of the gauge in use? I mostly use the Camaster FTC feature like Jim. For zeroing manually I use a taper gauge between...
I am building a sipo (African Mahogany) door with jambs and trim. Looking back at some threads here I am considering using Gripper for primer and SW...
Joe, how do you deal with the screw holes for clear finished work? Filler? Screws or nails into the top face simplifies things a lot if the holes are...
For hand-fed curves with a bottom mounted bearing or guide collar I like to use toggle clamps with sandpaper glued to a 19mm jig under the stock. For...
How is the planer table height adjusted? On my old Powermatic there are two acme threaded rods running through threaded flange nuts set in the table...
When I use pocket screws on dense wood close to the end of a stile I use a 1/8" x 6" aircraft drill to drill a pilot hole. Self-drilling screws help,...
You can draw and generate toolpaths within Fusion 360. If you're already proficient in drawing with that program it probably makes sense to stay with...
Assuming you have a disc holder with a mandrel, chuck it in the drill and have at it. (How to play the flute: blow in one end and run your fingers up...
40 years in the trade, freelance cabinet and furniture maker, still eager to learn. "I don't feel like an old man, I feel like a young man who has something wrong with him."
Home Page
Find latest posts
View Articles
View Blog Entries