It requires a bit of floor space, but you can avoid flipping the pieces by rotating the outfeed cart 180* while rolling it back to the infeed side.
...
I had an Excalibur attachment on a Unisaw for about 20 years. Once I replaced the bowed guide rail and reinforced the angle braces it worked well for...
One thing I should point out is that having a three phase dust collector means that the phase converter will be running most of the time. If most of...
When I worked in a shop that had both a track saw and a full size sliding table saw I would have received the side eye at best and more likely a good...
For me the advantage of a slider is as much about ergonomics and saving my back as about saving time. You appear relatively young - if you stick with...
The 1100 cfm figure is at 0" static pressure with the stock filter in place and 5' of inlet hose. Flow figures are meaningless without an associated...
Same power, different run times. I have 2 A/hr batteries on my Bosch 18v drill/driver set and they work fine. A 5A/hr battery would be nice for work...
The gray wheels are practically worthless for grinding tools efficiently. The difference between them and the white wheels is less than that between...
You can take the temper out of carbon steel with any type of grinder if you are not paying attention. CBN makes it more difficult. I think CBN wheels...
40 years in the trade, freelance cabinet and furniture maker, still eager to learn. "I don't feel like an old man, I feel like a young man who has something wrong with him."
Home Page
Find latest posts
View Articles
View Blog Entries